Back to Blog
How-to Guides 2026-11-16 PupClub Couture 0 views

Puppy Collar & Lead Set Berry Red: First-Walk Setup Guide

Puppy Collar & Lead Set Berry Red: First-Walk Setup Guide

A step-by-step guide to fitting the Berry Red puppy collar, attaching the lead, and running first-walk checks with the PupClub Couture starter set.

Before the first walk: what the Berry Red set gives you

The Puppy Collar & Lead Set - Berry Red is a starter kit built around a 22–30cm adjustable collar and a 4ft lead. The collar has a D ring for attaching the lead or an ID tag, and the lead has a padded neoprene handle and high-quality hardware. Because the collar is fully adjustable, you can set it to your puppy's current neck size and loosen it as they grow.

The set is designed for puppies, but no accessory is indestructible. Check the collar and lead regularly for wear and tear, and treat the fit as something you recheck often rather than set once.

Key measurements to know before fitting

  • Puppy Collar & Lead Set - Berry Red: Collar adjusts from 22cm to 30cm with a width of approximately 1.5cm. This range tells you whether the collar will fit your puppy now and how much room it has to grow.
    Puppy Collar & Lead Set - Berry Red
    Puppy Collar & Lead Set - Berry Red
  • Puppy Collar & Lead Set - Berry Red: Lead is 4ft long and 15mm wide, with a padded neoprene handle. A 4ft lead keeps a young puppy close on early walks, and the padded handle adds comfort for the handler.

How to fit the collar on your puppy

Work through these checks in order. The two-finger rule is the simplest way to confirm the collar is snug but not tight.

  1. Measure the neck first: Use a soft tape or a strip of paper to measure around your puppy's neck. Compare that number with the 22–30cm adjustable range before you put the collar on.
  2. Set the collar to the measured size: Adjust the collar so it sits comfortably around the neck. The Berry Red collar is fully adjustable across its range, so you can fine-tune the fit.
  3. Check the two-finger gap: You should be able to fit two fingers under the collar around the neck. If you cannot, loosen it; if the collar slides easily over the head, tighten it.
  4. Attach the lead to the D ring: Clip the lead to the D ring on the collar. The same D ring can hold an ID tag, so you do not need a separate attachment point.
  5. Recheck as your puppy grows: Puppies grow quickly. Check the collar regularly and adjust it as their neck size changes, rather than assuming the first fit will last.

First-walk checkpoints

Before you head out, run through these quick checks. They focus on the set's supplied features and safe handling, not on training methods or exercise duration.

  • Collar fit: Confirm the two-finger gap still applies after the collar has been on for a few minutes. A puppy that pulls or scratches at the collar may need a small adjustment.
  • Lead connection: Check that the lead clip is fully closed on the D ring. Give the lead a gentle tug before you start walking to confirm the connection is secure.
  • Handle comfort: The padded neoprene handle is there to make holding the lead more comfortable. Grip it naturally and keep the 4ft length from tangling around your hand.
  • Wear and tear: Look over the collar and lead for fraying, loose stitching, or hardware damage. No accessory is indestructible, so replace or repair anything that looks worn.

What this set does not decide for you

The Berry Red set gives you a collar, lead, and D ring, but it does not set rules for how long or how far a puppy should walk. Those decisions depend on your puppy's age, breed, and health, and they are best discussed with your vet. The set also does not include an ID tag, so you will need to add one to the D ring if your puppy does not already wear one.

If you are unsure about sizing, reach out to PupClub Couture via the online chat before your first walk. The store also offers hassle-free returns, so you can exchange the set if the fit is not right.

Related Articles

Customer Service
Home
Products
Cart
Profile